Filter
Top Products
4 Replacement Procedures 4.6 Memory Module
4-20 Satellite/E200/E205 Maintenance Manual
Installing the Memory Module
Install the memory module according to the following procedures and Figures 4-8, after
checking that the computer is turned off in boot mode.
Note: The slot A is reserved for main memory. Use the slot B for expanded memory. If
only one card is installed, use the slot A.
1. Insert the memory module into the connector at an angle of 45 degrees.
2. Press down on the memory module so that it is secured with both memory lock
latches.
After the computer is turned on, check the hardware configuration in the Hardware Setup or
TSETUP program to make sure that the installed memory module has been recognized by the
system. If it has not been recognized yet, check the connections