Filter
Top Products
4 Replacement Procedures 4.4 Bottom Cover
4-16 Satellite/E200/E205 Maintenance Manual
Installing the Bottom Cover
Install the Bottom cover with the display assembly according to the following procedures and
Figures 4-5, 4-6.
1. Hold up the bottom cover.
2. Connect the LED board cable from CN205.
3. Connect the RGB board cable from CN204.
4. Seat the bottom cover, adjusting its position.
5. Place the Left and right side hinge cover in the correct position.
6. Secure the following 13 screws on the bottom cover:
- Six M2.5x5 white flat head screws.
- Three M2x6 black flat head screws.
- Two M2.5x4 black flat head screws.
- Two M2.5x6 black flat head screws.
7. Stick following 9 seal tapes:
- Four seal tapes on front side.
- One seal tape on right side.
- Two seal tapes on rear side
- Two seal tapes on back side.
8. Place the bottom cover in the correct position and secure the following 15 latches, in
that order:
- Four bottom latches on right sides.
- Two latches on right sides and three latches on left side.
- Six front latches.
9. Restore the normal computer placement then open the display panel and secure the
following 6 screws:
- Five M2x6 black flat head screws.
- One M2x5 white flat head screw.