Filter
Top Products
1 Setting up PostScript and/or PCL printing with Windows 95/98/Me
This chapter describes installing software and setting up printing from a
Windows-based computer running Windows 95/98/Me, Windows NT 4.0,
or Windows 2000.
The general steps for installing the software are:
• Install the PostScript printer driver or PCL printer driver and corresponding
printer driver files.
• Set up the printer driver to communicate with the GA-1040.
• Install the Command WorkStation software on the designated Windows 95/98/Me,
Windows NT 4.0, or Windows 2000 workstation(s).
• Configure the connection for Fiery Link and the Command WorkStation.
• Setup IPP printing for Windows 2000.
• Copy additional files from the User Software CD as needed.
Setting up PostScript and/or PCL printing with
Windows 95/98/Me
To set up the GA-1040 as a PostScript or PCL printer, you must install the PostScript
or PCL printer drivers for Windows 95/98/Me and the corresponding printer
description files. You can also install the Agfa Monotype Font Manager. Afterwards,
you configure the particular type of print connection between the workstation and the
GA-1040.
N
OTE
:
Using the PostScript driver requires either the HDD option or the PostScript
option installed on the copier.
The following procedure describes using the User Software CD to install the GA-1040
as a local (LPT1) printer. The procedures after that describe completing the print
connection for a network printer.
Installing
User Software
on a Windows
Computer