Filter
Top Products
72 Setting Up TopAccess
TO SET UP TOPACCESS ON THE GA-1040 (STATIC IP, RARP, BOOTP)
1. Press the PRINTER/NETWORK key, then press ON/OFF and OFF LINE.
2. Press SETTING and ADMIN.
3. Enter the GA-1040 password and press SET.
4. Press Protocol Setup>TCP/IP>Ethernet.
5. Assign the IP address Subnetmask and Gateway address according to your network
environment.
6. Press UTILITY and FUNCTION.
7. Press Reset.
TO SET UP CLIENT WORKSTATIONS TO USE TOPACCESS
1. Enable TCP/IP networking.
2. Make sure the workstation has a valid, unique IP address.
3. Make sure the workstation is installed with one of the following Internet browsers:
Windows 95/98/Me, Windows NT 4.0, and Windows 2000
—Either Netscape
Communicator v4.5 or later or Microsoft Internet Explorer v4.0.1 and SP1, or later
NOTE: Netscape and Microsoft continue to release frequent updates to their browsers.
As support cannot be guaranteed for all versions, use the versions specified above for
best results.
4. Make sure Java is enabled in your Internet browser.
For more information on setting up the GA-1040 and your network, see the
Configuration Guide.