Filter
Top Products
B070/B071 3-2 PTM
Using the SP Mode
SP command numbers can be entered directly (if you know the entire number) or
the command can be selected from the menus.
Direct Entry
If you know all seven digits of the SP code, enter the seven numbers and press
Enter key .
However, if you do not know all the numbers, enter only the first four numbers of
the seven-digit SP and press Enter key . The display goes immediately to the
first SP of that group. Then you can use the buttons to browse to the desired
selection.
Button Selection Entry
1. Refer to the SP Mode Tables at the end of this section to find the SP that you
want to adjust.
2. Press the Group number on the left side SP Mode window that contains the SP
that you want to adjust.
3. Use the scrolling buttons in the center of the SP mode window to display the
SP number that you want to open, then, press that number to expand the list.
4. Use the center touch-panel buttons to scroll to the number and title of the item
that you want to set, and press Enter key . The small entry box on the right
is activated and displays the default or the current setting below.
5. To enter a setting
• Press key to enter a minus sign. Then use the keypad to enter the
appropriate number. The number you enter will write over the previous
setting.
• Press to enter the setting. (If you enter a number that is out of range, the
key press is ignored.)
• Press Clear key to cancel the data.
6. If you need to perform a test print, press Copy Window to open the copy
window and select the settings for the test print. Press Start C key.
7. Press SP Mode (highlighted) in the copy window to return to the SP mode
display.
8. When you are finished, press Exit twice to return to the copy window.