Filter
Top Products
6
SETUP FLOW
After operating each procedure, please check the checkbox ( ) in front of each procedure so
that you can make sure completing the operation for setup.
Setup Flow for Windows
For Parallel Printing
Connecting the GA-1040
Connect the GA-1040 and a computer with a parallel cable.
P12 “CONNECTING TO THE PARALLEL PORT”
Installing the Printer Driver
Install the printer drivers using the installer in the CD-ROM.
P64 “Installing the Printer Driver for Parallel Printing”
Configuring the Options
Configure the option settings on the printer driver.
P109 “Configuring the Options”
For SMB Printing
Connecting the GA-1040
Connect the GA-1040 to your network with a network cable.
P13 “CONNECTING TO THE NETWORK”
Preparing to use the TopAccess
Set the TCP/IP protocol to use the TopAccess. When the printer is connected to the TCP/IP
network, you can use the TopAccess, a web-based utility, to remotely set up the printer from
your computer.
P16 “SETTING UP THE TCP/IP”
Setting up the Printing Service
Enable the Windows Printing Service using TopAccess.
P54 “SETTING UP THE WINDOWS PRINTING”
Installing the Printer Driver
Install the printer drivers for the SMB Printing.
P67 “Installing the Printer Driver for SMB Printing”