Filter
Top Products
2.15 Bridge media Slot Troubleshooting 2 Troubleshooting
2.15 Bridge media Slot Troubleshooting
To check if the Bridge media slot is good or no good, follow the troubleshooting procedures
below as instructed.
Procedure 1: Check on Windows XP Tablet PC Edition
Procedure 2: Connector Check and Replacement Check
Procedure 1 Check on Windows XP Tablet PC Edition
Insert a Bridge media (SD memory card/SDIO card/Memory stick/Memory stick Pro/
xD Picture card/Multimedia card) into the slot. Check if the installed Windows XP Tablet PC
Edition recognizes automatically the Bridge media and the data in the Bridge media can be
read.
If the card is not recognized or data are not read, go to Procedure 2.
Procedure 2 Connector Check and Replacement Check
The Bridge media is connected to the connector IS2101 of the system board.
Bridge media supports SD memory card/SDIO card/Memory stick/Memory stick Pro/
xD Picture card/Multimedia card.
Check 1 Bridge media and system board may be disconnected. Make sure the Bridge media
is firmly inserted to IS2101 on the system board. If not, insert it firmly. If the
Bridge media is still not functioning properly, perform Check 2.
Check 2 Bridge media may be faulty. Replace it with a new one following the step in
Chapter 4. If the problem continues, perform Check 3.
Check 3 System Board may be faulty. Replace it with a new one following the step in
Chapter 4.
Satellite R20/TECRA M7 Maintenance Manual (960-572) [CONFIDENTIAL] 2-51