Filter
Top Products
4.16 Wireless LAN card 4 Replacement Procedures
4.16 Wireless LAN card
Removing the Wireless LAN card
To remove the Wireless LAN card, follow the steps below. (See Figure 4-24.)
CAUTION: Do not try to remove the wireless LAN card with the computer turned on.
The computer or the wireless LAN card can be damaged. Do not touch the
connectors on the wireless LAN card on the computer. Debris on the
connectors may cause the wireless LAN card access problems.
1. Remove the following screw and wireless LAN card cover. (Some models are not
equipped with the wireless LAN card cover.)
• M2×4B BIND screw ×1 (For models without wireless LAN card cover)
or
• M2×4B Security torx screw ×1 (For models with wireless LAN card cover)
2. Disconnect the wireless LAN antenna cables (black and white) from the wireless
LAN card using an antenna coaxial cable disconnector.
3. Remove the following screw and disconnect the wireless LAN card from the
connector on the system board.
• M2×4B BIND screw ×1
M2
×
4B BIND or M2×4B Securit
y
torx
Wireless LAN card cover
(Some models are not equipped with
the wireless LAN card cover.)
Wireless LAN antenna
cable (black)
Wireless LAN antenna
cable (white)
Wireless LAN card
M2×4B BIND
Figure 4-24 Removing the Wireless LAN card
(For an instance, Wireless LAN card cover and Security torx model is described.)
Satellite R20/TECRA M7 Maintenance Manual (960-572) [CONFIDENTIAL] 4-39