Filter
Top Products
© 2005 - 2011 TOSHIBA TEC CORPORATION All rights reserved MR-3018/3020/3021/3022
DISASSEMBLY AND ASSEMBLY
4 - 21
4
[D] Original feed motor (M1)
[E] Original feed motor drive section
(1) Take off the rear cover.
( P. 4-2 "[B] Rear cover")
(2) Disconnect 1 connector. Then remove 2
screws to take off the original feed motor.
Fig. 4-57
(1) Take off the rear cover.
( P. 4-2 "[B] Rear cover")
(2) Disconnect 1 connector, and then remove 1
spring. (Spring: Outside diameter of coil –
ø9.6 mm, acceptable turns of coil – 12 turns)
Fig. 4-58
(3) Remove 3 screws, and then take off the orig-
inal feed motor with its bracket.
Note: Note:
When the unit is being assembled, tempo-
rarily tighten the screws removed at step (3)
and then attach the spring removed at step
(2). Then fully tighten these screws.
Fig. 4-59
Connector
Original feed motor
Connector
Spring
Original feed motor
05/12