Filter
Top Products
7-8 User’s Manual
HW Setup
Other settings
This section explains items and procedures other than those setup using
the HW Setup program.
Starting and Ending the BIOS Setup Program
Starting the BIOS Setup Program
1. Switch on your computer while pressing the Esc key.
If “Password =” is displayed, enter either the Supervisor Password,
if one is set, or the user password and press the Enter key.
Please refer to Chapter 6, the TOSHIBA Password Utility, for details
about the user password.
The “Check system. Then press [F1] key.” message is
displayed.
2. Press the F1 key.
The BIOS setup program will start up.
Ending the BIOS Setup Program
Save the changes and end the program.
1. Press the End Key.
The “Are you sure? (Y/N) The changes you made will
cause the system to reboot.” message is displayed.
2. Press the Y key.
The configured settings are saved and the BIOS setup program ends.
The computer may reboot depending on the settings that were
modified.
Ending the BIOS Setup Program Halfway
The configuration settings can be terminated halfway without saving any of
the changes made.
1. Press the Esc key.
The “Exit without saving? (Y/N)” message is displayed.
2. Press the Y key.
The BIOS setup program will end.
Notes before using the BIOS Setup
■ In most cases, changes to the system’s configuration should be made
within Windows by using applications such as TOSHIBA HW Setup,
TOSHIBA Password Utility, TOSHIBA Power Saver, Windows
Device Manager and so forth. If you make changes to the
configuration through the BIOS setup program, please be aware that
the configuration set through the Windows applications will take priority.
■ Changes to the settings within the BIOS setup program will not be
erased even if the power supply is switched off and the main battery
removed. However, if the built-in Real Time Clock (RTC) battery runs
out of power, most of the settings will revert back to their default values.
However, please note that the password will not be affected in this
instance.