Filter
Top Products
275
Using the RAID-0 or RAID-1 Utility
TOSHIBA RAID Console Utility
5.375 x 8.375 ver 2.3
Sample Confirm media check window
4 Click OK.
A media check may take from several minutes up to one hour
to be completed depending on the amount of data to be
checked.
You may use the computer while performing a media check;
however, the computer’s performance may be slower than
usual.
Breaking a RAID-0 array (striping)
If you want to permanently stop using the secondary internal
hard disk drive for RAID-0, you must reinstall the Windows
operating system from the Toshiba Recovery DVD that
shipped with your system.
Before breaking the RAID-0 array, make sure you back up all
data on your computer’s hard drives onto another storage
media. When a RAID-0 array is broken, all data on both your
primary and secondary hard disks is erased and cannot be
recovered. Toshiba is not responsible for any loss of data on
your hard disks.
To break the RAID-0 array:
1 Plug in the AC adapter and power on the computer. (The
computer must be running on power provided by the AC
adapter to perform these steps.)