Filter
Top Products
Figure F-1. TRANZport 232 (Front and Rear Views)
Typical Installation Use the steps below as a guide to connect a TRANZport 232 in a typical
TRANZ 460 configuration.
Note: In the following configuration the TRANZ 460 receives its power from
the TRANZport 232. The power pack that came with your TRANZ 460
should be used with the TRANZport 232. For all other terminal
configurations, you should obtain a TRANZ 460 power pack certified for use
in your country. If you have purchased a TRANZport 232 configuration
containing an optional power pack, use the provided power pack.
1. Unplug all power cords connected in the present configuration.
2. Disconnect printer from the TRANZ 460 serial port.
3. Plug the disconnected end of the printer serial cable into the connector
labeled A on the TRANZport 232.
4. Using one of the supplied serial interface cables (PN 00446-04), plug the
DIN-8 end into the TRANZ 460 serial port. Plug the DB-9 end of this
cable into the connector labeled TERMINAL on the TRANZport 232.
5. Plug the DIN-8 end of the second supplied serial interface cable into the
connector labeled B on the TRANZport 232. The DB-9 end of this cable
should be plugged into the DVM (Data Over Voice Multiplexer).
6. Plug one end of the power pass-thru cable into the Power In connector on
the TRANZ 460. Plug the other end of this cable into the connector
labeled POWER OUT on the TRANZport 232. Plug the TRANZ 460
power pack into the connector labeled POWER IN on the TRANZport
232.
7. Plug the power pack into an indoor, 120 volt AC outlet.
8. Plug in all other power cords (Printer 150/250, DVM, etc.).
A-Port
Connector
(DIN-8)
B-Port
Connector
(DIN-8)
DIP Switch
(RTS/DTR
Selector Switch)
POWER IN
Connector
POWER OUT
Connector
TERMINAL Connector
(DB-9 Interface Cable
Connector)
FDC Retail/Debit Purchasing Card Reference Manual
F - 2 TRANZ 460 Terminal