Filter
Top Products
Figure 3-6. TRANZport 232 Data Connections
DTR/RTS Switch and
Power Connections
1. Set the DTR/RTS switch on the TRANZport 232 to the UP position.
2. Plug one end of the power pass-thru cable into the Power In connector
on the TRANZ 460. Plug the other end of this cable into the connector
labeled POWER OUT on the TRANZport 232. Plug the TRANZ 460 power
pack into the connector labeled POWER IN on the TRANZport 232.
3. Plug the power pack into an indoor, 120 volt AC outlet.
Figure 3-7. TRANZ 460/TRANZport 232 Power Connections
4. Remove the paper roll cover as shown in Figure 3-8 to expose the on/off
switch on the inside back panel. Turn the battery on by sliding the
switch to the right "on" position.
5. Once the battery is turned "on" and the terminal is connected to the power
pack, notice that the POWER indicator at the top, left-hand corner of the
terminal comes on, either "blinking" on and off (indicating that the battery
is recharging) or "steady" (indicating that the battery is already fully
charged).
6. Upon receiving power the terminal displays "FRET462" to identify the
software application.
Note: The application is loaded only if it came from
your bank or Independent Service Organization (ISO). If you received a
terminal directly from VeriFone, contact your bank or ISO for application
download information.
TRANZ 460 Power Pack
(or optional TRANZport 232 power pack)
POWER IN
POWER IN
POWER OUT
Connect to
serial port on
DVM
Serial Interface Cable
B Port
DTR switch up
TRANZport 232
(front view)
FDC Retail/Debit Purchasing Card Reference Manual
3 - 4 TRANZ 460 Terminal