Filter
Top Products
Installation
This application can operate in either of two configurations, both using a
single telephone line. One configuration consists of a TRANZ 460 terminal
and a standard telephone sharing the same telephone line. The other
configuration supports up to five terminals per phone line, using a multi-lane
traffic controller.
Single Terminal
Configuration
In a single terminal configuration, there are two RS-232 devices: a
Data-Over-Voice Multiplexer (DVM) and a printer. The TRANZ 460 terminal
can connect to a TRANZport 232 device, which enables it to communicate
with the DVM and printer, or both terminal and printer can connect directly to
the DVM, provided the printer port on that device is compatible with VeriFone
equipment.
Follow these steps to connect your TRANZ 460 terminal to the printer and to
the DVM device. Refer also to Appendix F,
TRANZport 232
, for more
complete details of the various serial interface and power cables available to
install your DDOV TRANZ 460 terminal. Figures 3-5 through 3-7 illustrate
connections to a TRANZport 232 device.
Note: In the following configuration the TRANZ 460 receives its power from
the TRANZport 232. The power pack that came with your TRANZ 460
should be used with the TRANZport 232.
Data Connections 1. Using one of the supplied serial interface cables (PN 00446-04), plug the
DIN-8 end into the TRANZ 460 serial port. Plug the DB-9 end of this
cable into the connector labeled TERMINAL on the TRANZport 232.
(See Figure 3-5.)
2. Plug the DIN-8 end of the second supplied serial interface cable into the
connector labeled B on the TRANZport 232. The DB-9 end of this cable
should be plugged into the DVM (Figure 3-6).
Figure 3-5. Serial Interface Cable Connection
Note: If connection is via DVM only, the terminal’s RS-232 cable plugs into
the DVM’s RS-232 connector. The DVM also features a 25-pin connector for
the serial port connection.
Serial Interface Cable
TRANZport 232
(back view)
TRANZ 460
3. TRANZ 460 Terminal
TRANZ 460 Terminal 3 - 3