Filter
Top Products
Unpacking
Carefully inspect the shipping carton and its contents for shipping damage. If
the PINpad 201 unit was damaged during shipment, immediately file a claim
with the shipping company and notify VeriFone, Inc.
Warning: Do not use the PINpad unit if it has been damaged.
1. Remove the PINpad device from the shipping carton.
2. Remove any protective plastic wrap and place the unit on a table or
countertop.
3. Remove the protective plastic wrap from the display panel.
4. Replace all the packing materials, close the lid and save the carton for
repacking or moving the PINpad device in the future.
Connecting the PINpad Device to the Terminal
The PINpad 201 device rear panel has a modular, 4-position interface port
for power and communication connection to the TRANZ 460. (The rear panel
also has a power pin connector, which is not used for this system
implementation.) Figure C-2 illustrates how to connect the PINpad unit to the
TRANZ 460. For other terminal connections, refer to Section 3 of this manual.
Warning: Turn off or unplug the terminal whenever you connect or disconnect
the PINpad device. Be sure the terminal is not processing data when you cut
power. Memory corruption and data loss can result.
1. Turn off or unplug the power to the terminal.
2. Connect one end of the cord to the terminal.
3. Connect the other end of the cord to the PINpad device.
4. Turn on or plug in the power to the terminal.
Figure C-2. PINpad Device to TRANZ 460 Connection
PINpad Device
TRANZ 460
FDC Retail/Debit Purchasing Card Reference Manual
C - 2 TRANZ 460 Terminal