Filter
Top Products
Note: In a single terminal configuration, the printer and terminal connect
separately to the DVM, each using its own cable. In a multi-lane
configuration, the printer and terminal connect to the MTC via one "Smart" Y
cable.
Loading the Printer with Paper
Caution: Because impact, friction, temperature, humidity, light, and oil affect
the coloring and storage characteristics of no-carbon-required paper, handle
this type of paper carefully. Never load a roll of paper that has any folds,
wrinkles, tears, or holes at edges or in the printing area.
1. Remove both printer mechanism cover and paper roll cover.
2. Unroll several inches of paper. With the cut edges of the paper pointing
up, insert the paper spindle through the paper roll and place the roll into
the slots on the inside of the terminal.
3. Slide the edges of the paper over the second paper spindle and insert
them into the slot at back of printer, making sure that the left edge of the
paper is at the left edge of the slot and that the roll is aligned properly
(upper and lower paper edges match).
4. Press the On/Feed key located at the top of the terminal to feed the paper
through the printer (see top right, Figure 3-11).
5. Replace the paper roll cover.
6. Replace the printer mechanism cover on the terminal, making sure the
paper is free to feed through the opening on the top of the cover.
Figure 3-11. Loading the Printer with Paper
On/Feed Key
FDC Retail/Debit Purchasing Card Reference Manual
3 - 6 TRANZ 460 Terminal