Filter
Top Products
Note: FDC TRANZ software has been designed with ten unique Setup
codes: BLUE + 4 + Codes 0 through 9. You should always use the Setup
functions to enter data in the various fields. Use this alternate programming
procedure only for entering data in other unique fields such as Fraud Control.
Setting the Calendar/Clock
You can set the calendar/clock after unpacking your new TRANZ 460
terminal. The calendar/clock will not copy when you perform a
terminal-to-terminal application copy.
To set the clock, simultaneously press the [*] and [3] keys. Release both
keys. The display shows:
Display Response
DIAGNOSTICS Press the [ALPHA] key.
RTC CHIP TEST Respond to each prompt that follows.
YEAR 1980-2079 = Enter a 2-digit number (94, 95, etc.), then
press [ENTER].
MONTH = Enter a number (1–12) representing the
month, then press [ENTER].
January = 1
February = 2
March = 3, etc.
DAY = Enter the day of the month, then press
[ENTER]. You can enter "2" or "02" for
February 2nd.
HOUR 0-23 = Enter a number, 0 through 23, to identify the
hour of the day in 24-hour format, then press
[ENTER]. Enter "10" for 10 A.M. or "16" for 4
P.M.
MINUTES = Enter the number of minutes, from 0 to 59,
currently past the hour, then press [ENTER].
For example, enter "14" if the time is 10:14.
SECONDS = Enter the number of seconds, from 0 to 59,
currently past the minute, then press
[ENTER]. For example, enter "23" if the time
is 10:14 and 23 seconds.
(day of week, date and
time)
The terminal displays the new date and time.
Note: If you press the [CLEAR] key at any time before you complete this
function, the terminal does not accept any of the data you entered and will
default to a "zero out" date and time.
FDC Retail/Debit Purchasing Card Reference Manual
4 - 2 TRANZ 460 Terminal