Filter
Top Products
8. Supervisor Mode: Permits or denies port access to Supervisor Mode. When enabled
(Permit), and the valid Supervisor Password is entered, the port will be allowed to invoke
Supervisor Level commands. If disabled (Deny), the port may not enter Supervisor
Mode, even when the Supervisor Password is entered. (Default = Permit).
9. Logoff Character: Defines the Logoff Character for this port. The Logoff Character
determines the command sequence that must be issued at this port in order to disconnect
from a second port (Resident Disconnect). Note the following:
•
The default Logoff Character is "+". As a result, the default Resident Disconnect
Sequence is [Enter]+++[Enter].
•
The default three character Resident Disconnect Sequence uses the format
"[Enter]LLL[Enter]", where L is the Logoff Character. If the one character disconnect
is selected (see item 10), a resident connection is terminated by simply typing the
Logoff Character once (without carriage returns).
10. Sequence Disconnect: Enables/Disables and configures the Resident Disconnect
command. This prompt offers the option to either disable the Sequence Disconnect,
select a three character format, or select a one character format. (Default = Three
Characters). Note the following:
• When a Resident Connection is initiated, the CMS will send a message which lists the
connected ports, and displays the one character or three character disconnect command
that will be required in order to terminate the connection.
• The One Character Disconnect sequence is intended for situations where the destination
port should not receive the disconnect command. When the Three Character format is
selected, the disconnect sequence will pass through to the destination port prior to
breaking the connection.
• When the Three Character format is selected, the Resident Disconnect Sequence will
use the format "[Enter]LLL[Enter]", where L is the selected Logoff Character.
•
When the One Character format is selected, resident connections are terminated by
entering the selected Logoff Character only. There is no need to press [Enter] before
and after the Logoff Character when the One Character format is selected.
5-9
CMS Series - Console Management Switches, User's Guide Configuration