Filter
Top Products
5.6. Copying Parameters to All Ports
The /CP command (Copy Port Parameters) provides a convenient means for selecting similar
parameters for all CMS RS-232 ports.
When the /CP command is invoked, the unit will display a menu which allows you to select
port communication parameters, and then copy them to all CMS RS-232 ports. The Copy Port
Parameters menu can be used to set all parameters for all RS-232 Ports, or define only a select
group of parameters and then copy them to all ports.
Notes:
•
The /CP command will not copy parameters to the Network Port.
•
The /CP command is only available in Supervisor Mode.
•
The Copy Port Parameters Menu will not display the Port Password. This field
will read either “undefined” or “defined”, depending upon whether or not the Port
Password has been specified.
•
The /CP command cannot be used to set Ports 1 and 2 to Passive Mode or Buffer
Mode (Port Mode, Item 7).
•
The /CP command cannot be used to disable the Supervisor Mode at Ports 1 and 2
(Supervisor Mode, Item 8).
5-16
CMS Series - Console Management Switches, User's Guide Configuration
COPY PORT PARAMETERS:
1. Port Name:
2. Password:
3. Baud Rate:
4. Bits/Parity:
5. Stop Bits:
6. Handshake Mode:
7. Port Mode:
74. DTR Output:
8. Supervisor Mode:
9. Logoff Character:
10. Sequence Disconnect:
11. Timeout Disconnect:
12. Response Type:
13. Command Echo:
14. Accept Break:
(Note: Ports1&2will NOT have restricted values changed.)
Enter: Parameter # <CR> to define parameter value to copy to all ports,
-<CR> to remove all values set,
X<CR> to exit WITHOUT copy,
<ESC> to copy to all ports and exit ...
Figure 5.5: The Copy Port Parameters Menu