Filter
Top Products
As shown in Figure 6.1, The Port Status Screen lists the following items:
·
Name: The user-defined name for each port.
·
Password: The user-defined password for each port. Note that actual passwords are not
displayed; this column will read either “undefined” or “defined”. To display Port
Passwords, type /SP [Enter] (Supervisor Mode Only).
·
Status: The connect status of each port. When the port is connected, this column will list
the number of the other CMS port that is connected to this port. If the connected port is
listed as "Nn" (where "n" is a number from 1 to 6), this indicates that the corresponding
RS232 port is connected to the CMS Network port. The numbers N1 through N6 indicate
one of the six available telnet sessions.
·
Mode: The user-selected Port Mode. This column will read Any (Any-to-Any), Modem,
Passive, or Buffer, depending on the configuration selected for the port.
·
Buffer Count: Lists the amount of data (in bytes) stored in the buffer for this port.
6-2
CMS Series - Console Management Switches, User's Guide The Status Screens
PORT STATUS: Version 2.00, Site ID: WESTERN TELEMATIC INC.
PORT | NAME | PASSWORD | STATUS | MODE | BUFFER COUNT
-----+------------------+------------------+--------+--------+--------------
01 | (undefined) | (undefined) | Free | Any | 0
02 | (undefined) | (undefined) | Free | Any | 0
03 | (undefined) | (undefined) | Free | Any | 0
04 | (undefined) | (undefined) | Free | Any | 0
05 | (undefined) | (undefined) | Free | Any | 0
06 | (undefined) | (undefined) | Free | Any | 0
07 | (undefined) | (undefined) | Free | Any | 0
08 | (undefined) | (undefined) | Free | Any | 0
|||||
09 | (undefined) | (undefined) | Free | Any | 0
10 | (undefined) | (undefined) | Free | Any | 0
11 | (undefined) | (undefined) | Free | Any | 0
12 | (undefined) | (undefined) | Free | Any | 0
13 | (undefined) | (undefined) | Free | Any | 0
14 | (undefined) | (undefined) | Free | Any | 0
15 | (undefined) | (undefined) | Free | Any | 0
16 | (undefined) | (undefined) | Free | Any | 0
Enter /H for command menu.
Figure 6.1: The Port Status Screen (Supervisor Mode, Defaults Shown)