Filter
Top Products
The /W command uses the following format:
/W[P] xx [Enter]
Where:
P Is the command option to display port passwords. Note that when this option is
included (e.g. /WP 5), the Port Parameters Screen will display the Port Password,
if
defined. (Supervisor Mode Only).
xx is the desired port number. If the letter “N” is entered in place of a port number,
the /W command will display parameters for the Network Port.
Note: When the command mode is accessed via the Network Port using a Port
(User) password, the /W command will only display the Sequence Disconnect,
Logoff Character, and the status of the Accept Break item.
6-6
CMS Series - Console Management Switches, User's Guide The Status Screens
NETWORK CONFIGURATION:
NETWORK PARAMETERS
1. IP Address: 204.1.221.195
2. Subnet Mask: 255.255.255.0
3. Gateway Address: 204.1.221.193
4. IP Security Off
TELNET PORT PARAMETERS
11. Supervisor Mode(port23):Permit
12. Logoff Character: +
13. Sequence Disconnect: Three Characters
14. Timeout Disconnect: 15 Min
15. Response Type: Verbose
16. Command Echo: On
17. Accept Break: Yes
CMS>
Figure 6.5: The Port Parameters Screen (Network Port Shown)