Filter
Top Products
6.4. The Port Parameters Screens (/W)
The /W command displays more detailed information about an individual CMS port. Rather
than listing connection information for all ports like the Port Status Screens, the Port
Parameters screen lists all defined parameters for a specific port.
The /W command is available in both Supervisor Mode and Port (User) Mode. Note however,
that when you log in with a Port password, the CMS will only display information for ports
that are "owned" by the password entered at login.
The /W command can be applied to either an RS232 Port or the CMS Network Port. Figure 6.4
shows the screen that is displayed when the /W command is applied to an RS232 Port, and
Figure 6.5 shows the screen displayed when the command is applied to the Network Port.
If Supervisor Mode is active, the /W command offers the option to display the Port Password
for each RS232 port. Normally, the Password field will read either “defined” or “undefined”,
depending upon whether or not the password for that port has been specified. To display the
Port Parameters Screen with the Port Password, type /WP, followed by the desired RS232 port
number, and then press [Enter]. Note that the /WP command option is not available in User
Mode, and will not display the Supervisor Password.
6-5
CMS Series - Console Management Switches, User's Guide The Status Screens
PORT PARAMETERS #03:
1. Port Name: (undefined)
2. Password: (undefined)
3. Baud Rate: 9600
4. Bits/Parity: 8-None
5. Stop Bits: 1
6. Handshake Mode: RTS/CTS
7. Port Mode: Any-to-Any
74. DTR Output: Pulse
8. Supervisor Mode: Permit
9. Logoff Character: +
10. Sequence Disconnect: Three Characters
11. Timeout Disconnect: Off
12. Response Type: Verbose
13. Command Echo: On
14. Accept Break: Yes
Figure 6.4: The Port Parameters Screen (RS232 Port Shown)