Xantrex Technology XDC 600-20 Power Supply User Manual


 
Remote Operation
4–2 TM-XDOP-01XN
Overview
In addition to front panel operation, the power supply can be operated remotely
through the following interfaces:
Analog 0 to 5V, 0 to 10V
•RS-232
GPIB (with optional GPIB/CANbus card)
Multichannel (with optional GPIB/CANbus card)
The connecting ports for these interfaces are shown in, Figure 1-6 and Figure 4-1.
The remote interfaces (except for the analog programming interface) accept
commands in 2 formats: IEEE 488.2 common commands and SCPI commands.
SCPI commands that are aliases for the IEEE 488.2 common commands have
been provided for use over the multichannel interface.
The IEEE 488.2 common commands that are supported are:
For a detailed listing of all SCPI commands, see Table C-1 to Table C-14.
Before using a SCPI command, familiarize yourself with the information in
“Using SCPI Commands” on page C–5.
*CLS *PSC <on_off_state>
*ESE *RCL <user_setting>
*ESE <enable_mask> *RST
*ESR? *SAV <user_setting>
*IDN? *SDS
*OPC *SRE?
*OPC? *SRE
<enable_mask>
*OPT *STB
*PRE? *TRG
*PRE <enable_mask> *TST?
*PSC? *WAI
TM-XDOP-01XN.book Page 2 Monday, July 17, 2006 11:19 AM