Xantrex Technology XDC 600-20 Power Supply User Manual


 
About The XDC Power Supply
1–2 TM-XDOP-01XN
Overview
The XDC Series of digital, programmable DC power supplies is designed for use in
OEM, ATE, burn-in, magnet charging, and other high power systems for a broad
range of applications. The XDC uses our newly developed digital technology which,
combined with “Soft Switching,” provides superior performance and a high level of
user control through both front panel and remote interfaces.
Features
Digital processing for highly accurate control
Ten, 99-step auto sequences for easy bench-top programming of complex test
routines
Ten stored settings
Zero voltage (soft) switching for low noise output, improved efficiency and
higher reliability
Active Power Factor Correction (PFC) for lower input current draw and lower
current harmonic generation
Remote voltage sense with 5V line drop compensation
Automatic Voltage/Current mode crossover
Constant power mode
Seven load protection mechanisms
Alarms and messages for over- and under-programmed trip points
Auxiliary status lines for monitoring power supply conditions
Remote interlock and trigger ports
Selectable standby, last setting, programmed sequence and other power-on
defaults
Active current sharing with parallel connected units for higher power
requirements. (These features are available when the power supply is equipped
with the optional GPIB/CANbus interface card.)
Standard RS-232 remote control interface and optional GPIB (IEEE 488.2) port
CANbus communications link for multichannel addressing, and master/slave
current sharing*
Extensive SCPI command set
Keypad, knobs, and arrow keys for fast and tactile front panel operation
Bright vacuum fluorescent display with annunciators to indicate complete
supply status at a glance
Front panel, software-based calibration
Fully isolated analog programming and readback capabilities
CE Mark, CSA Certified, FCC Compliance
TM-XDOP-01XN.book Page 2 Monday, July 17, 2006 11:19 AM