Xantrex Technology XDC 600-20 Power Supply User Manual


 
Power Supply Operation
TM-XDOP-01XN 3–23
Recall Settings
After you have saved one or more settings, you can press RECALL to retrieve
them from the power supply’s non-volatile memory or to run an auto-sequence
program. (You can also recall stored settings through your Power ON
configuration. See “Configure Power ON Settings” on page 3–29.)
To retrieve a setting using RECALL:
Four options are available from the Recall memory:
1. Last Setting: Returns the setpoints to values stored before power was turned
off.
2. User Settings: Returns the setpoints to one of ten possible saved values.
3. Factory Preset: Returns the setpoints to the original out-of-the-box values.
4. Auto Sequence: Returns control of the setpoints to one of ten possible saved
programs. (For further information, see “Program Auto Sequence” on page 3–
33.)
To access these options, press RECALL repeatedly until the correct option
appears, or press the arrow keys. Pressing RECALL lets you scroll through the
options in the direction listed above. Pressing the arrow keys lets you cycle
through the options in either direction.
Step # Do This You Will See
1 Last Setting
2 User Settings
3
User Set 1
a
a. If you want a different setting besides Set 1, use the arrow keys or numeric keypad.
4
This setting is retrieved from memory, the power supply’s output
changes to match the setting, and the display returns to its default
operating mode.
RECALL
RECALL
ENTER
ENTER
TM-XDOP-01XN.book Page 23 Monday, July 17, 2006 11:19 AM