Filter
Top Products
PRODUCT OVERVIEW
1-2 XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE
Host connectivity options The DocuPrint IPS can be set up to receive data from the IBM host
in one of two ways:
• Through a bus and tag channel connection.
Note: If your system will be channel-attached, the printer
controller requires an additional component called a Host
Channel Unit (HCU), which interfaces between the IBM host and
the IPS controller.
• Through a Token Ring or Ethernet interface using TCP/IP (the
HCU is not used).
Note: A transmission rate of at least 16 megabits per second
should be used with a Token Ring interface on the IPS. (Overall
performance depends on network traffic and job density.)
• The software supports Token Ring over TCP/IP, and
Ethernet over TCP/IP, with the exception of VM and VSE
platforms.
• Of the other platforms that support TCP/IP, only the RS/
6000 supports 100 Mb Ethernet connectivity.
Figure 1-1. Xerox 96/4635/180 IPS: Channel-attached
configuration
1 Host system (PC or mainframe)
2 96, 4635, or 180 IPS printer
3 Printer interface cable (DCIM2)
4 Sun workstation controller
5 SCSI interface
6 Host Channel Unit (HCU)
7 Bus and tag cables