Filter
Top Products
PRINTER SPECIFICATIONS AND REQUIREMENTS
6-20 XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE
Space planning guidelines
When determining your space requirements and planning for shared
space between your printers, it is important to consider all of the
components you plan to install.
To ensure all of the space requirements are met, it is important to
work with your Xerox representative.
Before installation, you must consider the following:
• Clearance space requirements where you intend to install the
printer
• Recommended cable lengths and locations (refer to the
“System connections” chapter of this guide for more
information)
• Delivery access requirements
• Floor leveling.
Clearance space requirements
The printer must be installed in a fixed location that provides the
following clearance space:
• 36 inches / 91.4 cm on all sides of each component
• 24 inches / 61 cm of exclusive operator area in front of each
component
• 78 inches / 198 cm of vertical clearance throughout the entire
area.
Note: There must be a total of 50 inches / 126.9 cm of clearance
space in front of the printer.
Shared space
It is best to provide the full amount of clearance space around the
hardware components. Your environment may require you to use
shared space between components, such as between the printer and
the printer controller or between the printer and another Xerox
printing system. You can share the 36-inch / 91.4 cm clearance
space around each component, as long as you follow these rules:
• Space may be shared only with other Xerox equipment.
• Components may share the 36-inch / 91.4 cm general service
clearance areas, but they may not share the 24-inch / 61 cm
operator area in front of each component.
• There must be 78 inches / 198 cm of vertical clearance
throughout the entire area.
Note: Finishers attached to your bypass transport and feeders
attached to your DocuPrint 4635, 96, or 180 printer through the input
enablement device may occupy shared space with Xerox equipment.
However, they must be removable to allow servicing of the DocuPrint