Filter
Top Products
PRINTER SPECIFICATIONS AND REQUIREMENTS
XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE 6-7
Space requirements
You should consider the following factors when deciding where to
place the printing system hardware components:
• Adequate work space and service clearance around the
equipment
• Proximity to electrical and network connectors
• Security of the work area. You may need to place the system in
an area where you can restrict access to it. This may be
important if your personnel need to print confidential documents
or if you are concerned with unauthorized usage.
Dimensions and weights of the printer components are listed in this
section, along with diagrams, to help you visualize the sizes and total
space requirements.
Note: There must be a 78-inch / 198-cm vertical clearance
throughout the entire area. Your printer must be installed in a fixed
location with a minimum clearance space of 36 inches / 91.4 cm
around all sides of each piece of equipment for access by service
personnel. In addition, there must be 50 inches / 126.9 cm clearance
space in front of the printer.
For information on clearance space and other space planning
considerations, refer to the “Space planning guidelines” section of
this chapter. Contact your service representative if you have
questions not specifically addressed in this guide.
Printer placement
The following configurations are available for the Xerox 96/4635/180
printers:
• Printer + inverter feeder/stacker (96 only)
• Printer + inverter feeder/stacker + feeder/stacker
• Printer + inverter feeder/stacker + feeder/stacker + feeder/
stacker (4635 and 180 only)
• Printer + inverter feeder/stacker + feeder/stacker + feeder/
stacker + feeder/stacker (4635 and 180 only).
Measurements and a top-view diagram for each of these
configurations is provided on the following pages.