Filter
Top Products
DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
E-4 XEROX DOCUPRINT 96/4635/180 IPS INSTALLATION PLANNING GUIDE
Following is an example of the JES2 Initialization Dataset
required commands:
Configuring in JES3 Follow these steps to configure the PSF printer in JES3:
1. Locate the JES3 initialization dataset (commonly known as
Initialization Deck) in the JES3 catalogued JCL Procedure.
(This is normally kept in SYS1.PROCLIB, although your system
may use a different library.)
The JES3 PROC has a JES3IN DD statement, which points to
the initialization dataset. The default initialization deck is in
SYS1.SAMPLIB (member JES3IN00); however, you should
verify your location by looking at the JES3 procedure.
2. Enter the following required commands in the JES3 initialization
deck to define the PSF functional subsystem (FSS):
• One FSSDEF statement for each PSF functional
subsystem
• One DEVICE statement for each functional subsystem
application (FSA) under control of the FSS.
MARK NO Installation
preferences
YES or NO YES specifies for IPS that
there is either offsetting or
stitching of jobs, subject to
value of COPYMARK
parameter and setting on
IPS.
MODE FSS (if FSS=
is coded)
Must be FSS FSS MODE=FSS should be
specified.
PRESELECT YES Installation
preferences
YES or NO Specifies whether output
datasets are preselected
for this FSA.
ROUTECDE None Installation printer
name standards
1 to 4 destination
names
If WS if F, only output with
these destinations is
selected for this printer.
START YES Should be NO for TCP/
IP printers.
YES or NO START=NO should be
specified so TCP/IP can be
started before the FSS.
TRKCELL no See JES2 SPOOLDEF
statement
YES or NO IBM recommends YES.
WS None Installation
preferences
See JES2
Initialization and
Tuning Manual.
Consider CL, R, and F.
(See JES2 Initialization
and Tuning Manual.)
Table E-1.JES2 FSS statement parameters (continued)
Item
description Default Source of value
Range of
acceptable values Comments Your value
Table E-2.JES2 Initialization Dataset commands example
FSS (FSS1) PROC=FSSPROC1,HASPFSSM=HASPFSSM,AUTOSTOP=YES
PRT0001 CLASS=E,FSS=FSS1,MODE=FSS,PRESELCT=YES,
START-NO,TRKCELL=YES,WS=(Q)