Filter
Top Products
3. Preinstallation
This chapter will assist you in preparing for the installation of your
4635 Laser Printing System (LPS). Consult your customer support
representative for the requirements of any optional equipment or
communications devices that may have been ordered. For
example, the peripheral cabinet and bypass transport options
have space requirements, and Ethernet requires that you establish
an Ethernet address. Refer to the “LPS options” chapter of this
guide for further information.
Keep in mind that preparing for your LPS installation is a
responsibility shared by both your site and your Xerox or Rank
Xerox representatives. Your representatives are available to
discuss installation issues and to assist you in completing the site
installation responsibilities.
Prior to installation, a site must be carefully selected and
prepared, and supplies must be ordered. This chapter will help
you accomplish these tasks by providing the following
information:
• LPS space and delivery requirements
• Environmental and electrical requirements
• Cabling requirements
• Supply requirements.
If you have purchased additional equipment for use with your
4635 LPS, such as finishers or feeders, from a company other
than Xerox, it is important to remember to work with the
representatives of the company when planning the installation.
Space planning, electrical and environmental requirements, and
so forth, are important considerations to remember.
LPS space and delivery requirements
Dimensions and weights of the 4635 LPS system controller and
printer are listed in this chapter, along with diagrams to help you
visualize the sizes and total space requirements.
Note: There must be a 78-inch/1981-mm vertical clearance
throughout the entire area. In addition, your LPS must be
installed in a fixed location with a minimum clearance space of
36 inches/914 mm around all sides of each piece of equipment
for access by service personnel. 50 inches/1270 mm clearance is
required in front of the 4635 printer (refer to figure 3-3).
For information on sharing space and other space planning
considerations, refer to the “Space planning guidelines” section
of this chapter. Space planning templates, a space planning
template transparency, and a grid are also provided at the end of
this chapter to assist you in planning the placement of your 4635
LPS. Contact your service representative if you have questions
not specifically addressed in this guide.
XEROX 4635 LASER PRINTING SYSTEM INSTALLATION PLANNING GUIDE 3-1