Filter
Top Products
Connecting the ADSL2+ and POTS Connectors
4929-A2-ZN20-30 4929 DSLAM Installation and User’s Guide
27
Connecting the ADSL2+ and POTS Connectors
DSL connector supports the tip and ring connections of up to 24 DSL ports
over a 50-position cable. A POTS (plain old telephone service) splitter
connector is also provided in certain models. If your model does not contain
an integrated POTS splitter, you must connect the unit to a separate POTS
splitter.
To cable the DSL Ports:
1 Insert a cable tie (provided) through the top of the anchor mount next to
the ADSL2+ connector.
2 If the connector for your cable has a short captive screw, attach the cable
to the ADSL2+ connector and fasten it to the jack screw with its short
captive screw.
3 If the connector for your cable has a long captive screw, remove the
provided jack screw from the threaded hole next to the ADSL2+
connector. Attach the cable connector to the unit using the long captive
screw.
4 Tighten the cable tie around the connector and trim the excess.
5 If you are using an integrated POTS splitter, repeat Step 1 through Step 4,
substituting POTS for ADSL2+.
Short
Screw
#4-40
Jack Screw
02-17083
Anchor
Mount
50-Pin
Connector
02-17346
Anchor
Mount
50-Pin
Connector
Long
Screw
02-17084