Filter
Top Products
CLI Commands
4929-A2-ZN20-30 4929 DSLAM Installation and User’s Guide
77
The commands use the following parameters.
DISABLE_WEB_SERVER] Disables access to the DSLAM using the web server.
ENABLE_TELNET Enables access to the DSLAM using Telnet.
ENABLE_TFTP Enables access to the DSLAM using Trivial File Transfer Protocol.
ENABLE_WEB_SERVER Enables access to the DSLAM using the web server.
HELP Lists available commands and their syntax.
LOGOUT Ends the CLI session.
SET Sets a configuration option. Most SET commands require that slot
be specified, and allow port optionally to be specified. Exceptions
are the two system SET commands for session timeout and system
name.
Syntax:
set cli_session_timeout seconds
set system_name name
set slot 1 [[port] [all, por t_number]] [item] [value]
Items and values for SET commands are shown in Table 4, Set and
Show Command Items and Values.
SHOW Shows a configuration option. SHOW commands require that slot be
specified, and allow port optionally to be specified.
Syntax:
show slot 1 [[port] [all, port_number]] [item] [value]
Items and values for SHOW commands are shown in Table 4, Set
and Show Command Items and Values.
WHO Shows who is logged in the system.
Table 3: CLI Commands (Sheet 2 of 2)
Command Description
Table 4: Set and Show Command Items and Values (Sheet 1 of 3)
Items Values
ADSL_ENCAPSULATION [RFC1483-LLC,RFC1483-VCMUX]
ADSL_PORT_MODE [ON,OFF,ADAPTIVE,FIXED_ADAPTIVE]
ADSL_SPEED [XXXX YYYY]
Where:
XXXX = downstream rate (in kbps) and
YYYY = upstream rate (in kbps)