Filter
Top Products
Prestige 153/153X WAN Bridge/Routers
Hardware Installation & Initial Setup 2-5
This section outlines how to connect your Prestige 153/153X to the LAN and the WAN. Refer to
Figure 2-1 or Figure 2-2, depending on your model, when you are making the connections. To
minimize confusion over the various RJ-45 ports, they are color coordinated as follows:
Port Color
Ethernet 10Base-T Port Metallic
WAN Ports Black
Console Port Off-White
The enclosed cables are of the same color as the ports for which they are intended, however, it is
still important for you to make sure that the correct cable is used for each connection; otherwise,
your Prestige could be damaged.
Step 1. Connect your Computer and your Prestige
For the initial setup of your Prestige, you need to use a terminal emulator software on a
workstation and connect it to the Prestige through the console port. Connect the RJ-45 end of the
enclosed console cable to the console port of the Prestige and the other end to a serial port
(COM1, COM2 or other COM port) of your workstation. Use the enclosed DB-25/DB-9
converter if necessary.
After your Prestige has been successfully installed and configured, you can modify the setup
remotely through telnet sessions. See Chapter 12 - Telnet Configuration and Capabilities for
detailed instructions.
Step 2. Connect WAN Devices to your Prestige
Connect the DTE port of a WAN device to a WAN port (black) on the Prestige using an
appropriate cable, and connect the WAN device to the telephone network. Please consult the
documentation of your WAN device for detailed information when making the connections.
Step 3. Connect your Prestige to Ethernet
Connect one end of an UTP (Unshielded Twisted Pair) cable to the Ethernet port (metallic) of the
Prestige and the other to a 10Base-T hub using a straight-through UTP (Unshielded Twisted Pair)
cable with RJ-45 connectors. If you connect the Prestige to a workstation directly without a hub,
you must use a crossover cable.
Step 4. Connect the Power Adapter to your Prestige
Connect the power adapter to the port labeled POWER on the rear panel of your Prestige.