Filter
Top Products
Prestige 153/153X WAN Bridge/Routers
Remote Node Configuration 4-7
Table 4-1. Remote Node Profile Menu Fields for Dial-up Lines (continued)
Field Description Options
Edit PPP Options To edit the PPP options for this remote node, move the
cursor to this field, use the space bar to select [Yes] and
press [Enter]. This will bring you to Menu 11.2 - Remote
Node PPP Options. For more information on configuring
PPP options, see the section Editing PPP Options.
Press space bar
to select [Yes]
then press [Enter]
Rem IP Addr This is a required field [?] if IP routing is enabled. Enter
the IP address of the remote gateway.
Edit IP/IPX/Bridge Options To edit the parameters, select [Yes] and press [Enter].
This will bring you to Menu 11.3 – Remote Node
Network Layer Options. For more information on this
screen, refer to the chapter pertaining to your specific
protocol.
Press space bar
to select [Yes]
then press [Enter]
Edit Script Options To edit the parameters, select [Yes] and press [Enter].
This will bring you to Menu 11.4 – Remote Node Script.
Select [Yes] then
press [Enter]
Telco Option:
Allocated Budget
(min)
This field sets a ceiling for outgoing call time to this
remote node. The default for this field is [0] for no
budget control.
Default = 0
Period (hr) This field will set the time interval to reset the above
outgoing call budget control.
Session Options:
Input Filter Sets,
Output Filter Sets and
Call Filter Sets
In these fields, enter the filter set(s) you wish to apply to
the incoming and outgoing traffic between this remote
node and your Prestige. You can choose from 12
different filter sets. In addition, you can link up to 4 filter
sets together for further customization, e.g., 1, 5, 9, 12.
Note that spaces are accepted in this field.
For more information on customizing your filter sets, see
Chapter 9. The default is blank, i.e., no filters defined.
Default=Blank