Filter
Top Products
Chapter 21 IP Source Guard
ES-2024 Series User’s Guide
165
Figure 85 ARP Inspection Configure
The following table describes the labels in this screen.
Table 59 ARP Inspection Configure
LABEL DESCRIPTION
Active Select this to enable ARP inspection on the Switch. You still have to
enable ARP inspection on specific VLAN and specify trusted ports.
Filter Aging Time
Filter aging time This setting has no effect on existing MAC address filters.
Enter how long (1-2147483647 seconds) the MAC address filter remains in
the Switch after the Switch identifies an unauthorized ARP packet. The
Switch automatically deletes the MAC address filter afterwards. Enter 0 if
you want the MAC address filter to be permanent.
Log Profile
Log buffer size Enter the maximum number (1-1024) of log messages that were generated
by ARP packets and have not been sent to the syslog server yet. Make
sure this number is appropriate for the specified Syslog rate and Log
interval.
If the number of log messages in the Switch exceeds this number, the
Switch stops recording log messages and simply starts counting the
number of entries that were dropped due to unavailable buffer. Click
Clearing log status table in the ARP Inspection Log Status screen to
clear the log and reset this counter. See Section 21.4.1 on page 163.