Filter
Top Products
Chapter 7 Basic Setting
ES-2024 Series User’s Guide
73
Static IP
Address
Select this option if you don't have a DHCP server or if you wish to assign static IP
address information to the Switch. You need to fill in the following fields when you
select this option.
IP Address Enter the IP address of your Switch in dotted decimal notation for example
192.168.1.1.
IP Subnet
Mask
Enter the IP subnet mask of your Switch in dotted decimal notation for example
255.255.255.0.
Default
Gateway
Enter the IP address of the default outgoing gateway in dotted decimal notation, for
example 192.168.1.254
VID Enter the VLAN identification number associated with the Switch IP address. This is
the VLAN ID of the CPU and is used for management only. The default is "1". All
ports, by default, are fixed members of this "management VLAN" in order to manage
the device from any port. If a port is not a member of this VLAN, then users on that
port cannot access the device. To access the Switch, make sure the port that you are
connected to is a member of Management VLAN.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Management IP Addresses
Configure the fields to set additional management IP address.
IP Address Enter the IP address for managing the Switch by the members of the VLAN specified
in the VID field below.
IP Subnet
Mask
Enter the IP subnet mask in dotted decimal notation. For example, 255.255.255.0.
VID Enter the VLAN identification number.
Default
Gateway
Enter the IP address of the default outgoing gateway in dotted decimal notation, for
example 192.168.1.254
Add Click Add to save the new rule to the Switch. It then displays in the summary table at
the bottom of the screen.
The Switch loses these changes if it is turned off or loses power, so use the Save link
on the top navigation panel to save your changes to the non-volatile memory when
you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Index This field displays the index number of an entry.
IP Address This field displays the management IP address of the Switch.
IP Subnet
Mask
This field displays the subnet mask for the corresponding IP address.
VID This field displays the VLAN identification number of the network.
Default
Gateway
This field displays the IP address of default gateway.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the Delete check boxes.
Table 11 Basic Setting > IP Setup (continued)
LABEL DESCRIPTION