Filter
Top Products
ES-3124PWR Ethernet Switch
Maintenance 24-5
Step 3. You must log in as an administrator. Enter “admin” when prompted for a username.
Step 4. Enter your password as requested (the default is “1234”).
Step 5. Enter “bin” to set transfer mode to binary.
Step 6. Use “put” to transfer files from the computer to the switch, for example, “put firmware.bin ras” transfers
the firmware on your computer (firmware.bin) to the switch and renames it “ras”. Similarly, “put
config.rom config” transfers the configuration file on your computer (config.rom) to the switch and
renames it “config”. Likewise “get config config.rom” transfers the configuration file on the switch to your
computer and renames it “config.rom.” See earlier in this chapter for more information on filename
conventions.
Step 7. Enter “quit” to exit the ftp prompt.
24.7.3 GUI-based FTP Clients
The following table describes some of the commands that you may see in GUI-based FTP clients.
Table 24-2 General Commands for GUI-based FTP Clients
COMMAND DESCRIPTION
Host Address Enter the address of the host server.
Login Type Anonymous.
This is when a user I.D. and password is automatically supplied to the server for
anonymous access. Anonymous logins will work only if your ISP or service
administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer Type Transfer files in either ASCII (plain text format) or in binary mode. Configuration and
firmware files should be transferred in binary mode.
Initial Remote Directory Specify the default remote directory (path).
Initial Local Directory Specify the default local directory (path).
24.7.4 FTP Restrictions
FTP will not work when:
• FTP service is disabled in the Access Control screen.
• The IP address(es) in the Secured Client Set in the Remote Management screen does not match the client
IP address. If it does not match, the switch will disconnect the Telnet session immediately.