Filter
Top Products
ES-3124PWR Ethernet Switch
30-12 Command Examples
An example is shown next.
Enable port one for configuration.
Enable broadcast control.
Set the number of broadband packets the interface receives per second
Figure 30-22 broadcast-limit Command Example
30.8.4 bandwidth-limit
Syntax:
bandwidth-limit
bandwidth-limit egress <Mbps>
bandwidth-limit ingress <Mbps>
where
Enables bandwidth control on the switch.
<Mbps>
Sets the maximum bandwidth allowed for outgoing traffic (egress) or
incoming traffic (ingress) on the switch.
An example is shown next.
Enable port one for configuration.
Enable bandwidth control.
Set the outgoing traffic bandwidth limit to 7Mbps.
Set the incoming traffic bandwidth limit to 9Mbps.
Figure 30-23 bandwidth-limit Command Example
30.8.5 mirror
Syntax:
mirror
mirror dir <ingress|egress|both>
where
Enables port mirroring on the interface.
ras(config)# interface 1
ras(config-interface)# broadcast-limit
ras(config-interface)# broadcast-limit 21
ras(config)# interface 1
ras(config-interface)# bandwidth-limit
ras(config-interface)# bandwidth-limit egress 7
ras(config-interface)# bandwidth-limit ingress 9