Filter
Top Products
ES-3124PWR Ethernet Switch
IEEE 802.1Q Tagged VLAN Commands 31-3
An example is shown next.
Figure 31-3 GARP STATUS Command Example
31.4.2 GARP Timer
Syntax:
garp join <msec> leave <msec> leaveall <msec>
where
join <msec>
=
This sets the duration of the Join Period timer for GVRP in milliseconds.
Each port has a Join Period timer. The allowed Join Time range is
between 100 and 32767 milliseconds; the default is 200 milliseconds.
leave <msec>
=
This sets the duration of the Leave Period timer for GVRP in
milliseconds. Each port has a single Leave Period timer. Leave Time
must be two times larger than Join Timer; the default is 600 milliseconds.
leaveall <msec>
=
This sets the duration of the Leave All Period timer for GVRP in
milliseconds. Each port has a single Leave All Period timer. Leave All
Timer must be larger than Leave Timer; the default is 10000
milliseconds.
This command sets the switch’s GARP timer settings, including the join, leave and leave all timers.
Switches join VLANs by making a declaration. A declaration is made by issuing a Join message using GARP.
Declarations are withdrawn by issuing a Leave message. A Leave All message terminates all registrations. GARP
timers set declaration timeout values.
The following example sets the Join Timer to 300 milliseconds, the Leave Timer to 800 milliseconds and the Leave
All Timer to 11000 milliseconds.
31.4.3 GVRP Timer
Syntax:
show vlan1q gvrp
This command shows the switch’s GVRP settings.
An example is shown next.
ras
(config)#
garp
join
300
leave
800
leaveall
11000
ras# show garp
GARP Timer
------------------------
Join Timer :200
Leave Timer :600
Leave All Timer :10000
ras#