Filter
Top Products
ES-3124PWR Ethernet Switch
30-16 Command Examples
Syntax:
qos priority <0 .. 7>
where
<0 .. 7> Sets the quality of service priority for an interface(s).
An example is shown next.
Enable ports one, three, four and five for configuration.
Set the IEEE 802.1p quality of service priority as four (4).
Figure 30-31 qos priority Command Example
30.8.13 name
Syntax:
name <port-name-string>
where
<port-name-
string>
Sets a name for your port interface(s).
An example is shown next.
Enable ports one, three, four and five for configuration.
Set a name for the interfaces.
Figure 30-32 name Command Example
30.8.14 speed-duplex
Syntax:
speed-duplex <auto|10-half|10-full|100-half|100-full|1000-full>
where
<auto|10-
half|10-
full|100-
half|100-
full|1000-
full>
Sets the duplex mode (half, full) and speed (10/100/1000 Mbps) of the
connection on the interface. Selecting auto (auto-negotiation) makes one port
able to negotiate with a peer automatically to obtain the connection speed
and duplex mode that both ends support.
An example is shown next.
ras(config)# interface 1,3
-
5
ras(config-interface)# qos priority 4
ras(config)# interface 1,3
-
5
ras(config-interface)# name Test