Filter
Top Products
Chapter 10 Interface
ZyWALL USG 1000 User’s Guide
216
Figure 141 Network > Interface > Auxiliary
Each field is described in the table below.
Table 61 Network > Interface > Auxiliary
LABEL DESCRIPTION
Auxiliary Interface
Properties
Enable Select this to turn on the auxiliary dial up interface. The interface does not dial
out, however, unless it is part of a trunk and load-balancing conditions are
satisfied.
Description Enter a description of this interface. It is not used elsewhere. You can use
alphanumeric and ()+/:=?!*#@$_%- characters, and it can be up to 60
characters long.
Port Speed Select the speed of the connection between the ZyWALL and external
computer.
Dialing Type Tone - select this if the telephone uses tone-based dialing.
Pulse - select this if the telephone uses pulse-based dialing.
Initial String Enter the AT command string to initialize the external modem.
ATZ is the most
common string, but you should check the manual for the external modem for
additional commands.
Auxiliary
Configuration
Phone Number Enter the phone number to dial here. You can use 1-20 numbers, commas (,),
or plus signs (+). Use a comma to pause during dialing. Use a plus sign to tell
the external modem to make an international call.
User Name Enter the user name required for authentication.
Password Enter the password required for authentication.
Retype to
confirm
Enter the password again to make sure you have not typed it incorrectly.