Filter
Top Products
Chapter 17 HTTP Redirect
ZyWALL USG 1000 User’s Guide
263
Figure 169 Network > HTTP Redirect
The following table describes the labels in this screen.
17.4 HTTP Redirect Edit
Click Network > HTTP Redirect to open the HTTP Redirect screen. Then click the Add or
Edit icon to open the HTTP Redirect Edit screen where you can configure the rule.
Figure 170 Network > HTTP Redirect > Edit
The following table describes the labels in this screen.
Table 81 Network > HTTP Redirect
LABEL DESCRIPTION
Name This is the descriptive name (up to 31 printable characters) of a rule.
Interface This is the interface on which the request must be received.
Proxy Server This is the IP address of the proxy server.
Port This is the service port number used by the proxy server.
Add icon Click the Add icon in the heading row to add a new entry.
The Active icon displays whether the rule is enabled or not. Click the Active icon to
activate or deactivate the rule. Make sure you click Apply to save and apply the
change.
Click the Edit icon to go to the screen where you can edit the rule on the ZyWALL.
Click the Remove icon to delete an existing rule from the ZyWALL. A window
displays asking you to confirm that you want to delete the rule.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.
Table 82 Network > HTTP Redirect > Edit
LABEL DESCRIPTION
Enable Use this option to turn the HTTP redirect rule on or off.
Name Enter a name to identify this rule. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.