Chapter 12 Policy and Static Routes
ZyWALL USG 1000 User’s Guide
230
Figure 150 Network > Routing > Policy Route > Edit
The following table describes the labels in this screen.
Table 67 Network > Routing > Policy Route > Edit
LABEL DESCRIPTION
Configuration
Enable Select this to activate the policy.
Description Enter a descriptive name of up to 31 printable ASCII characters for the policy.
Criteria
User Select a user name or user group from which the packets are sent. Select Create
Object to configure a new user account (see Section 34.2.1 on page 506 for
details).
Incoming
Interface
Click Change... to select an interface or VPN tunnel through which the incoming
packets are received.
Source Address Select a source IP address object or select Create Object to configure a new one.
Destination
Address
Select a destination IP address object or select Create Object to configure a new
one.
Schedule Select a schedule or select Create Object to configure a new one (see Chapter 37
on page 527 for details). none means the route is active at all times if enabled.
Service Select a service or service group from the drop-down list box. Select Create
Object to add a new service. See Section 36.2.1 on page 523 for more
information.
Next-Hop