Filter
Top Products
Chapter 31 Content Filter Screens
ZyWALL USG 1000 User’s Guide
464
31.1.3 Content Filter Configuration Guidelines
You must configure an address object, a schedule object and a filtering profile before you can
set up a content filter policy. When the ZyWALL receives an HTTP request, the content filter
searches for a policy that matches the source address and time (schedule). The content filter
checks the policies in order (based on the policy numbers). When a matching policy is found,
the content filter allows or blocks the request depending on the settings of the filtering profile
specified by the policy. Some requests may not match any policy. The ZyWALL allows the
request if the default policy is not set to block. The ZyWALL blocks the request if the default
policy is set to block.
31.2 Content Filter General Screen
Click Anti-X > Content Filter > General to open the Content Filter General screen. Use
this screen to enable content filtering, view and order your list of content filter policies, create
a denial of access message or specify a redirect URL and check your external web filtering
service registration status.
Figure 347 Anti-X > Content Filter > General
The following table describes the labels in this screen.
Table 146 Anti-X > Content Filter > General
LABEL DESCRIPTION
General Setup
Enable Content Filter Select this check box to enable the content filter.
Policies This is a list of the configured content filter policies.