Filter
Top Products
Chapter 12 Policy and Static Routes
ZyWALL USG 1000 User’s Guide
233
12.6 Static Route Summary
Click Network > Routing > Static Route to open the Static Route screen.
Figure 152 Network > Routing > Static Route
The following table describes the labels in this screen.
12.7 Edit a Static Route
Select a static route index number and click Edit. The screen shown next appears. Use this
screen to configure the required information for a static route.
Figure 153 Network > Routing > Static Route > Edit
Table 68 Network > Routing > Static Route
LABEL DESCRIPTION
# This is the number of an individual static route.
Destination This is the destination IP address.
Subnet Mask This is the IP subnet mask.
Next-Hop This is the IP address of the next-hop gateway or the interface through which the
traffic is routed. The gateway is a router or switch on the same segment as your
ZyWALL's interface(s). The gateway helps forward packets to their destinations.
Metric This is the route’s priority among the ZyWALL’s routes. The smaller the number, the
higher priority the route has.
Add icon Click the Add icon to go to the screen where you can set up a static route on the
ZyWALL.
Click the Edit icon to go to the screen where you can edit the static route on the
ZyWALL.
Click the Remove icon to delete an existing static route from the ZyWALL. A window
displays asking you to confirm that you want to delete the routing policy.