Filter
Top Products
Chapter 44 Service Control
ZyWALL USG 1000 User’s Guide
592
44.4 Service Control Rules
Click Add or Edit in the Service Control table in a WWW, SSH, Telnet, FTP or SNMP
screen to add a service control rule.
Figure 429 System > Service Control Rule Edit
The following table describes the labels in this screen.
44.5 HTTPS Example
If you haven’t changed the default HTTPS port on the ZyWALL, then in your browser enter
“https://ZyWALL IP Address/” as the web site address where “ZyWALL IP Address” is the IP
address or domain name of the ZyWALL you wish to access.
Client
Authentication
Method
Select a method the HTTPS or HTTP server uses to authenticate a client.
You must have configured the authentication methods in the Auth. method screen.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.
Table 206 System > WWW (continued)
LABEL DESCRIPTION
Table 207 Edit Service Control Rule
LABEL DESCRIPTION
Address Object Select ALL to allow or deny any computer to communicate with the ZyWALL using
this service.
Select a predefined address object to just allow or deny the computer with the IP
address that you specified to access the ZyWALL using this service.
Zone Select ALL to allow or prevent any ZyWALL zones from being accessed using this
service.
Select a predefined ZyWALL zone on which a incoming service is allowed or
denied.
Action Select Accept to allow the user to access the ZyWALL from the specified
computers.
Select Deny to block the user’s access to the ZyWALL from the specified
computers.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving