Filter
Top Products
Chapter 13 Troubleshooting
WAP3205 User’s Guide
136
13.3 Internet Access
I cannot access the Internet.
1 Check the hardware connections, and make sure the LEDs are behaving as
expected. See the Quick Start Guide.
2 Make sure the WAP3205 is connected to a broadband modem or router with
Internet access.
3 If you are trying to access the Internet wirelessly, make sure the wireless settings
in the wireless client are the same as the settings in the AP.
•Go to Network > Wireless LAN > General > WDS and check if the
WAP3205 is set to bridge mode. Select Disable and try to connect to the
Internet again.
4 Disconnect all the cables from your device, and follow the directions in the Quick
Start Guide again.
5 Go to Maintenance > Sys OP Mode. Check your System Operation Mode
setting.
• Select Access Point Mode if your WAP3205 bridges traffic between clients on
the same network.
• Select Client Mode if your WAP3205 needs a wireless client to connect to an
existing access point.
• Select Universal Repeater Mode if you want to have wireless clients
associate with the WAP3205 and also want to connect the WAP3205 to an
existing access point.
6 If the problem continues, contact your ISP.
I cannot access the Internet anymore. I had access to the Internet (with the
WAP3205), but my Internet connection is not available anymore.
1 Check the hardware connections, and make sure the LEDs are behaving as
expected. See the Quick Start Guide and Section 1.5 on page 20.
2 Reboot the WAP3205.
3 If the problem continues, contact your ISP.