Filter
Top Products
4 Windows 2000 Driver Setup
26
9
Follow the steps in the Completing NIC installation with Windows 2000 screen.
Click
Done
.
.
10
Click
Exit
.
11
Make sure the
3Com Installation CD
is still in the CD-ROM drive.
12
In the Found New Hardware Wizard screen, click
Next
.
13
The Install Hardware Device Drivers window appears. Click
Search for
a suitable driver
for my device, and then click
Next
.
14
The Locate Driver Files screen appears. Select the CD-ROM drives checkbox, and then
click
Next
.
15
The Driver Files Search Results screen appears. Verify that the correct path to the
driver software is shown (c:\winnt\inf\oem0.inf), and then click
Next
. If you acquired
the NIC software on a floppy disk or from the 3Com Web site, click where the NIC
driver files reside on your system.
16
The Completing the Found New Hardware Wizard screen appears. Click
Finish
.
After installation of the driver software is complete, you are ready to configure
NIC properties.
NOTE:
After installing the drivers, it is recommended that you install the 3Com
Management Programs to make full use of all management features. For more
information, see “3Com Management Programs” on page 85.