Filter
Top Products
370
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
no ip fib optimize
aggregation algorithm; the “no ip fib
optimize” disables the optimized IP route
aggregation algorithm.
17.2.2.2 IP Route Aggregation Configuration Command
17.2.2.2.1 ip fib optimize
Command: ip fib optimize
no ip fib optimize
Function: Enables the switch to use optimized IP route aggregation algorithm; the “no ip fib
optimize” disables the optimized IP route aggregation algorithm.
Default: Optimized IP route aggregation algorithm is disabled by default.
Command mode: Global Mode
Usage Guide: This command is used to optimize the aggregation algorithm: if the route table
contains no default route, the next hop most frequently referred to will be used to
construct a virtual default route to simplify the aggregation result. This method has
the benefit of more effectively simplifying the aggregation result. However, while
adding a virtual default route to the chip segment route table reduces CPU load, it
may introduce unnecessary data stream to switches of the next hop. In fact, part of
local switch CPU load is transferred to switches of the next hop.
Example: Disabling optimized IP route aggregation algorithm.
Switch(Config)# no ip fib optimize
17.2.3 IP Forwarding Troubleshooting Help
17.2.3.1 Monitor and Debug Commands
17.2.3.1.1 show ip traffic
Command: show ip traffic
Function: Display statistics for IP packets.
Command mode: Admin Mode
Usage Guide: Display statistics for IP and ICMP packets received/sent.
Example:
Switch#show ip traffic
IP statistics:
Rcvd: 128 total, 128 local destination
0 header errors, 0 address errors
0 unknown protocol, 0 discards
Frags: 0 reassembled, 0 timeouts
0 fragment rcvd, 0 fragment dropped