Filter
Top Products
483
EES4710BD 10 Slots L2/L3/L4 Chassis Switch
19.5.2.2.1 ip dvmrp cisco-compatible
Command: ip dvmrp cisco-compatible <A.B.C.D>
no ip dvmrp cisco-compatible <A.B.C.D>
Function: Enables connectivity with CISCO neighbor A, B, C, D; the “no ip dvmrp
cisco-compatible” command disables connectivity with CISCO neighbors.
Parameters: <A.B.C.D> are the Neighboring IP addresses
Default: The connectivity with CISCO neighbors is disabled by default.
Command mode: Interface Mode
Usage Guide: CISCO does not really implement DVMRP, but provides connectivity with DVMRP.
As CISCO routers/switches send report packets but not probe packets, neighbor
timeout issues should be addressed in establish connectivity with CISCO
routers/switches. Configuration of this command enables the switch to tell neighbor
timeout by report packet intervals (if no report message format a CISCO neighbor is
received in an interval three times of the report interval, that neighbor is considered
to be timeout.
Example: Enabling connectivity with CISCO neighbor 1.1.1.1.
Switch (Config)#interface vlan 1
Switch(Config-If-Vlan1)#ip dvmrp cisco-compatible 1.1.1.1
19.5.2.2.2 ip dvmrp enable
Command: ip dvmrp enable
no ip dvmrp enable
Function: Enables DVMRP on the interface; the “no ip dvmrp enable” command disables
DVMRP on the interface.
Parameters: N/A.
Default: DVMRP is disabled by default.
Command mode: Interface Mode
Usage Guide:
Example: Enabling DVMRP on interface vlan1.
Switch (Config)#interface vlan 1
Switch(Config-If-vlan1)#ip dvmrp enable
19.5.2.2.3 ip dvmrp graft-interval
Command: ip dvmrp graft-interval <time_val>
no ip dvmrp graft-interval
Function: Sets the interval for sending DVMRP graft messages; the “no ip dvmrp graft-interval”
command restores the default setting.
Parameters: <time_val> is the interval for sending DVMRP graft packets, ranging from 5 to 3600
seconds.
Parameters: The default interval for sending DVMRP graft messages is 5 seconds.
Command mode: Global Mode